Retaining

Product	603	638	641	648	660
Strength Required	High		Moderate	High
Handling in min.*	10	5	30	5	20
Diametric Clearance (mm)	Up to 0.1	Up to 0.25	Up to 0.1	Up to 0.15	Up to 0.50
Temperature Resistance	150°c			175°c	150°c
Pack Sizes
10 ml
50 ml
250 ml

Loctite 603

For retaining close fitting cylindrical parts (up to 0.1 mm gap), and for use on cylindrical fitting parts where thorough degreasing isnot possible. Tested and approved by leading manufacturers.

Loctite 638

Gives improved resistance to dynamic, axial and radial loads. Recommended for retaining shafts, gears, pulleys and similar cylindrical parts.

Loctite 641

Recommended for parts that will need subsequent dismantling i.e. retention of bearings onto shafts and into housings.

Loctite 648

Recommended for retaining parts with a clearance or interference fit i.e. retaining bushes, bearings seals, fans and liners.

Loctite 660 (Use with Activator 7649)

Used for repairing worn coaxial parts without requiring machining; enables re-use of out-of-true bearing seats, keys, splines, tapers or for retaining of shims.

Home Ball Screws/BallScrew Repair Lead Screws Complimentary Products Anti Vibration Mounts Bearings & Housings Circlips White Metal Bearings Rod Ends Ball Joints Machine Feet Couplings Grease Nipples and Grease Guns Chains and Sprockets BT Lock Bush Taper Bushes Sintered Bronze Bushes Needle Rollers Seals Disc Springs Ball Transfer Units O-Rings Loctite Retaining Instant Bonding Structural Bonding Sealing Activators and Primers Loctite Sticks Loctite Metal Set Threadlocking Thread Sealing Gasketing V-Rings Vee & Wedge Belts Pulleys Motor Mounts Three Phase Stainless Steel Motors Ball Screw Support Units Acme/Trappezoidal Job Vacancies About Us Information

Copyright 2004 Moore International Ltd

Unit 12, Cortry Close,  Poole, Dorset BH12 4BQ Tel. 01202 743222 Fax 01202 739955  Email Us